• Hello, this board in now turned off and no new posting.
    Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community!

Crystals in tne/dbol in oil

jsmithstone12

Registered
Joined
Mar 11, 2011
Messages
65
Reaction score
0
Points
0
Location
USA
i have 2 vials of tne/dbol in oil, one of them has a bunch of crystal floating around,, i dipped it in some hot water to see if they would melt, some did but not all.. they look like maybe some white almost crystals on the bottom of the via now ???? any help with this
 
i have 2 vials of tne/dbol in oil, one of them has a bunch of crystal floating around,, i dipped it in some hot water to see if they would melt, some did but not all.. they look like maybe some white almost crystals on the bottom of the via now ???? any help with this

It's a badly made blend, it crashed bro. Who ever you got if from doesn't know wtf they're doing. You can still pin it but you'll have to heat it everytime
 
wont it swell and hurt being like this
 
put it in the hot water for longer.... vent the vial with a pin in case you didnt do it last time.
 
i didnt vent it .but vent it how , just poke a hole ill try leaving in longer too
 
with needle if u only have insulin needles then stick in it and with plunger removed if u have just the needle stick it in the vial stopper
 
Listen just take a needle off the sringe and just leave the needle stuck in the top. Preheat your oven to 230 degrees and bake for 30 minutes. if you boil it make sure you have a rack on the bottom of the pot so the vial doesnt touch the pot which is hotter than 212.
 
i have 23g fillers, you think ishould pop onie of them in there

yes

Listen just take a needle off the sringe and just leave the needle stuck in the top. Preheat your oven to 230 degrees and bake for 30 minutes. if you boil it make sure you have a rack on the bottom of the pot so the vial doesnt touch the pot which is hotter than 212.

^^^^ for sure do this if you put it in a pot.
 
Back
Top